Product Details
- Product type: Power supply cover support bracket replacement
- Brand: Zodiac
- Part number: R5000100
- Compatible system type: Select Zodiac/Jandy electronic salt water chlorine generator systems
- Use: Supports the power supply cover area on compatible units
- Best use case: Replacing a damaged, missing, or worn support bracket without replacing the full system
- Package contents: Verify whether screws or mounting hardware are included
- Installation requirement: Confirm model compatibility and bracket position before ordering
Compatibility and Buyer Check
Before ordering, confirm that your Zodiac or Jandy system manual calls for part number R5000100. This bracket is listed for select Zodiac/Jandy electronic salt water chlorine generator systems, but compatibility should always be checked by exact model number.
Do not order by image alone. Brackets and cover supports can look similar, but the mounting points, length, shape, and fitment may not be the same.
If you are servicing the power area, check the Zodiac R0512100 power PCB assembly before replacing only the bracket. If the issue is related to the control board section, review the Zodiac R0512300 TS control PCB assembly as well.
What This Support Bracket Does
The power supply cover support bracket helps support and align the cover area on compatible Zodiac/Jandy salt water chlorine generator equipment. A damaged or missing bracket may leave the cover loose, poorly seated, or less secure during normal operation.
Replacing the bracket can help restore proper cover support when the rest of the power supply housing is still in good condition. It will not fix electrical faults, display problems, low chlorine output, a failed circuit board, or damaged wiring.
Before You Order
Check these details before purchasing:
- Confirm the exact part number R5000100.
- Verify your Zodiac/Jandy system model before ordering.
- Compare the bracket shape, length, holes, and mounting points with your existing part.
- Inspect the cover, housing, screws, and nearby mounting area for cracks or wear.
- If mounting screws are missing or damaged, compare with the Zodiac R0512800 PCB mounting screw replacement.
- If your issue is related to wiring or power connection, check the Zodiac R0402800 16 feet DC power cord replacement before ordering only the bracket.
- If you are working on the full power center setup, compare your system with the Zodiac 6613AP PureLink power center.
Installation Notes
Turn off power to the salt water chlorine generator and pool equipment before removing the old bracket or opening the power supply area. If the bracket is located near electrical components, use a qualified pool technician if you are not comfortable working around pool equipment wiring.
Install the replacement bracket in the same position as the original. Do not force the bracket into place or overtighten the mounting hardware. If the holes do not line up, stop and confirm model compatibility before continuing.
After installation, make sure the cover sits correctly, the bracket is secure, and no wires are pinched or pressed against sharp edges.
Maintenance Tips
To help keep the bracket and cover area secure:
- Inspect the cover support area during routine equipment checks.
- Replace missing or corroded mounting hardware when needed.
- Keep the power supply area protected from excess moisture.
- Do not force the cover closed if the bracket is misaligned.
- Check the housing for cracks before assuming the bracket is the only issue.
- Make sure all nearby wiring stays clear of sharp edges and mounting points.











