Product Details
- Model number: GLX-CTL-RITE
- Product type: Replacement electronic control unit
- Compatible use: Select Hayward AQR, Goldline, and AquaRite salt chlorine generator systems
- Compatible cell references: T-CELL-3, T-CELL-9, and T-CELL-15 systems where supported
- Product dimensions: Listed as 12.8 x 10 x 4.4 inches
- Item weight: Listed as 17.6 pounds
- Replacement part only: Not a complete chlorinator kit, salt cell, flow switch, transformer, or separate PCB board
- Salt cell included: No, unless clearly stated by the seller
- Flow switch included: No, unless clearly stated by the seller
- Professional installation: Recommended if you are not experienced with pool equipment wiring
- Package contents: Confirm all included parts, documents, and hardware before publishing
Compatibility Notes
Use this control unit only if your existing system supports the GLX-CTL-RITE replacement. If you are replacing only the internal board and not the full control enclosure, compare the GLX-PCB-RITE main circuit board before ordering the full control unit.
If the display is the main issue, check the AquaRite PCB display board before replacing the complete control unit.
For full system matching, compare your setup with the Hayward W3AQR15 AquaRite salt chlorination system and confirm the cell type, controller version, and wiring layout before purchase.
What the Control Unit Does
The control unit manages the operation of the salt chlorine generator. It works with the salt cell, flow switch, transformer, wiring, and pool water conditions so the system can produce chlorine from dissolved salt when operating correctly.
A control unit issue may show as no power, display problems, inconsistent readings, warning lights, or failure to control chlorine output. These symptoms can also be caused by a dirty salt cell, bad flow switch, loose wiring, blown fuse, transformer issue, damaged sensor connection, or incorrect water chemistry.
Installation Guidance
Turn off all power to the pool equipment before removing or installing the control unit. Electrical parts should be handled carefully, and professional installation is recommended if you are not experienced with pool equipment wiring.
Take clear photos of the old control unit, wiring terminals, cell connection, flow switch connection, grounding/bonding points, and breaker setup before removing anything. Do not guess on voltage, wiring, grounding, bonding, or installation direction.
If your system uses a T-CELL-15 style cell, confirm the cell and controller setup with a Hayward T-CELL-15 salt cell before ordering replacement control parts.
Troubleshooting Before Replacement
Before replacing the control unit, check whether the problem is caused by a dirty salt cell, incorrect salt level, poor water flow, loose wiring, tripped breaker, blown fuse, transformer issue, damaged sensor connection, or incorrect controller/cell type setting.
If the system shows a no-flow or flow-related message, inspect the Hayward GLX-FLO flow switch before replacing the control unit.
If the issue is limited to the board inside the control box, the GLX-PCB-RITE main circuit board may be the better replacement part than the full control unit.
Maintenance Tips
Keep the control box area dry, clean, and protected from direct water spray. Inspect wiring connections during routine equipment checks and avoid operating the system with loose, damaged, or corroded connections.
Do not open, modify, or repair the control unit unless the instructions allow it and the person working on it is qualified. Keep the salt cell clean, maintain proper water chemistry, and inspect related parts such as the flow switch and cell cable during pool maintenance.
Before You Order
Confirm that your existing system uses GLX-CTL-RITE and that the control unit matches your Hayward AQR, Goldline, or AquaRite setup. Also verify voltage, wiring layout, compatible salt cell type, controller/cell type setting, included accessories, installation requirements, and whether your issue is with the full control unit or a smaller replacement part such as a PCB board, display board, flow switch, transformer, fuse, or salt cell.
